United-office ULG 300 A1 User Manual Page 48

  • Download
  • Add to my manuals
  • Print
  • Page
    / 50
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 47
- 45 -
Anti-Blocking Switch (ABS)
At the start of the lamination process, the pouch
may be pulled in at an angle or jam itself inside the
appliance.
³ Turn the anti-blocking switch (ABS)
o
to the
position ABS.
The laminate pouch is not pulled any further in.
³ Remove the laminate pouch.
³ Turn the anti-blocking switch (ABS)
o
back to
the desired foil thickness.
³ Re-start the lamination process.
Trimming function
Should you wish to use the trimming function on the
foil guide rails
q
, dismantle the foil guide rails
q
.
³ If necessary, fold the documents support
s
down.
³ Adjust the cutter attachment
d
so that it forms
a straight face with the foil guide rails
q
.
³ Slide the cutting head
e
to the end stop (the
cutting head
e
can be slid to both ends of the
cutting rail
w
).
³ Flap the cutting rail
w
upwards with the roun-
ded grip and position the document on the foil
guide rails
q
. Restrain the document by sliding
the foil format restraint
r
together until they
touch both sides of the document.
³ Use the markings on the measurement table to
align the document precisely.
³ Flap the cutting rail
w
downwards so that it
engages.
³ Hold the paper in a secure position with your
left hand.
³ To trim, press the cutting head
e
down with
the right hand and then slide it with one pull or
push over the document.
Cleaning and care
Potentially fatal electrical shock:
Never open the appliance housing. There
are no user-serviceable elements inside.
Never submerse the appliance into water
or other liquids!
Cleaning the housing:
Clean the surface of the housing with a
slightly moistened cleaning cloth.
³ First remove the plug.
³ Allow the appliance to cool down completely.
³ Ensure that no moisture can permeate into the
appliance.
Cleaning the interior of the appliance:
With every lamination, contaminants are deposited on
the rollers inside the laminator. Over time, this reduces
the performance of the laminator. You should therefo-
re clean the rollers inside the laminator after use.
³ Prepare the appliance as described in chapter
"Preparing for hot lamination", up to the point
where the green indicator lamp "Ready"
y
glows.
³ Then run a sheet of DIN A3 paper, folded in
the middle (maximum thickness 1.0 mm) …
• without a laminating pouch and
• with the fold first
… slowly into the slot for manual pouch input
t
.
³ Release the sheet as soon as you notice it
being pulled in automatically.
The contaminants on the rollers inside the lami-
nator now firmly attach themselves to the sheet
of paper. The paper is discharged from the foil
slot
a
of the laminator.
³ Repeat this cleaning process several times.
Use a fresh clean sheet of paper each time.
When you no longer see any contaminants on the
paper, the rollers inside the laminator are clean.
IB_96273_ULG300A1_LB1 13.12.2013 11:49 Uhr Seite 45
Page view 47
1 2 ... 43 44 45 46 47 48 49 50

Comments to this Manuals

No comments